VSPHERE REPLIKASI-set ip

 vSphere replication appliance no networking detected

Rolling out vSphere Rep in 2 sites.

Running 6.5 up1 vSphere/ESXi

Installing 6.5.1 vSphere Replication

Site 1 (Main DC) Deployed OVF, VRep appliance installed without any issues.

Site 2 (DR Site) Used the same OVF as Site 1, when the appliance starts up, getting error No Networking detected. I have ran the command, but it will still not allow me to configure the network.

REPLY 

2 Kudos

• All forum topics
•  Previous Topic
• Next Topic 

1 Solution 

 vFantastic

Enthusiast

‎03-16-2021 06:29 AM

Console to VRMS and login.

Get the interface names with:

/opt/vmware/share/vami/vami_interfaces

Set the IP for the desired interface with: 

/opt/vmware/share/vami/vami_set_network <interface name> STATICV4 <IP Address> <NETMASK> <GATEWAY>

Set DNS with:

/opt/vmware/share/vami/vami_set_dns -d <domain suffix> <DNS IP1> <DNS IP2>

REBOOT

Resolved the issue for me on vSphere Replication 8.4. Hope this helps.

View solution in original post

VRMS Configure.png

17 KB

REPLY 

6 Kudos

19 Replies

 iopsGent

Enthusiast

‎08-09-2018 12:27 PM

So once you run this command, you don't get the menu?

/opt/vmware/share/vami/vami_config_net

Please consider marking this answer as "correct" or "helpful" if you think your questions have been answered.

REPLY 

0 Kudos

 hcgrobg

Contributor

‎08-09-2018 12:34 PM

I can run the cmd, it allows me to manually set the network info, but it gives an error when setting an IP to eth0

REPLY 

0 Kudos

 iopsGent

Enthusiast